Ho presentato la mia candidatura tramite l'università. La procedura ha richiesto un giorno. Ho sostenuto un colloquio presso Juniper Networks nel mese di gen 2013
Colloquio
Had taken a test to be shortlisted. Written test checked setup hold timings. Few aptitude questions. Few math problems.
Two technical rounds. One HR. HR consisted of asking my positional responsibilities in college.
Technical mostly involved regular digital logic testing. State diagrams for counter.
Domande di colloquio [1]
Domanda 1
Verilog description of logic. Digital logic questions
Ho presentato la mia candidatura online. La procedura ha richiesto una settimana. Ho sostenuto un colloquio presso Juniper Networks (Bengaluru) nel mese di set 2023
Colloquio
They had an aptitude round and who ever clear aptitude ,need to go through further 3 rounds and questions asked was very toughthrough further 3 rounds and questions asked was very tough
Domande di colloquio [1]
Domanda 1
Questions on digital electronics ,aptitude ,logical reasoning etc
La procedura ha richiesto 2 giorni. Ho sostenuto un colloquio presso Juniper Networks nel mese di mag 2015
Colloquio
It was a telephone interview with the hiring manager. Started with general stuff about tell me about yourself and later they explained more about the open position on hand. I had two rounds to confirm my skill level. Needed some preparation on interviewee side. If I had cleared this - the next step was two rounds of interview with team and managers.
Domande di colloquio [2]
Domanda 1
If you know system verilog. Write Fibonacci series. Can you reduce the variables?
Ho presentato la mia candidatura online. Ho sostenuto un colloquio presso Juniper Networks
Colloquio
one phone interview, ask questions about projects. one easy design questions. then on-site interview in the next week. 5 round interview. ask problem about timing issues, setup, hold time violations. pattern detection. writing some verilog code. ask about sram, ddr. ask about how to design a TCAM.
Domande di colloquio [1]
Domanda 1
if the inverter's input is connect to its output. how the output voltage curve should be like
