Ho presentato la mia candidatura online. La procedura ha richiesto 5 settimane. Ho sostenuto un colloquio presso Arm (Cambridge, East of England, England) nel mese di lug 2011
Colloquio
Can be divided into two parts, the phone interview, and the final face to face interview.
Both of them were VERY technical in nature and competency questions were absent. Questions related directly to Logic circuits, Logic Systems, VLSI, Solid state electronics and transistor physics. The interview itself is very grueling, in that questions are asked till you are at the very end of your knowledge and put your hands up and say that you don't know anything about what they have asked, and that point is used as a measure of how well you know your stuff. I thought I did terribly on both occasions, in that I did reach points at which I could not answer a question anymore, but I had in fact done quite well in actually arriving at that point.
Domande di colloquio [1]
Domanda 1
Was related to the effect of clock gate cloning and de-cloning.
Ho presentato la mia candidatura tramite segnalazione di un dipendente. Ho sostenuto un colloquio presso Arm (San Diego, CA) nel mese di apr 2026
Colloquio
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Domande di colloquio [1]
Domanda 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Domande di colloquio [1]
Domanda 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.