Ho presentato la mia candidatura tramite un'agenzia di reclutamento personale. La procedura ha richiesto un giorno. Ho sostenuto un colloquio presso Customised Technologies (Bengaluru) nel mese di lug 2016
Colloquio
i applied through elitmus. it was a test followed by technical interview and hr interview. it was 6 questions 30 minutes test. After the test they selected 4 out of approx 40 candidate. questions were not so tough but it was logical and time-taking. Some of the questions given below.
Domande di colloquio [1]
Domanda 1
1. what is rectifier? How does it work ?
2. Number system-Base conversion.
Ho presentato la mia candidatura tramite l'università. La procedura ha richiesto un giorno. Ho sostenuto un colloquio presso Customised Technologies (Bilāspur, Chhattisgarh) nel mese di set 2016
Colloquio
The company visited our campus. There were two rounds, Written & Interview. Written contained 6 questions( Basics from geometry & electronics). Questions were of basic level and very not very tough. None of the questions related to embedded were asked in the written test. ( Questions could have been of more standard )
Ho presentato la mia candidatura tramite un'agenzia di reclutamento personale. La procedura ha richiesto un giorno. Ho sostenuto un colloquio presso Customised Technologies (Bengaluru) nel mese di lug 2014
Colloquio
Written and Discussion round was there. In Written they ask some basic math and Electronics Question about resistor and Flowchart of a situation with solution.
They after the Written there is Discussion where Technical and HR will be at same Time. Discussion round was much easier you just have to convince them you are good enough.
Domande di colloquio [1]
Domanda 1
About the Project and Basic Question on Electronics and Electrical. and little bit of basic C
